204
2007 SEQUOIA from Aug. ’07 Prod. (OM34462U)
! If the ID code on the tire pressure
warning valves and transmitters is not
registered in the tire pressure warning
computer.
! If the tire inflation pressure is more
than 500 kPa (5.1 kgf/cm
2
or bar, 73
psi).
The system may be disabled in the follow-
ing conditions:
(When the condition becomes normal, the
system will work properly.)
! If the tire inflation pressure is more
than 500 kPa (5.1 kgf/cm
2
or bar, 73
psi).
! If electronic devices or facilities using
similar radio wave frequencies are
nearby.
! If a radio set at similar frequencies is
in use in the vehicle.
! If a window tint that affects the radio
wave signals is installed.
! If there is a lot of snow or ice on the
vehicle, in particular around the wheels
or wheel housings.
! If non−genuine Toyota wheels are used.
! If tire chains are used.
! If the spare tire is in a location subject
to poor radio wave signal reception.
If the tire pressure warning light continues
to come on after blinking for 1 minute
when the ignition key is turned to the
“ON” position, have the system checked
by your Toyota dealer.
Even if you use genuine wheels, the tire
pressure warning system may not work
properly with some types of tires.
Pushing the tire pressure warning reset
switch should not turn off the tire pressure
warning light.
For vehicles sold in U.S.A.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received, includ-
ing interference that may cause unde-
sired operation.
07 05.22
To Next Page
Loading...
