206
2007 SEQUOIA from Aug. ’07 Prod. (OM34462U)
u16051
TIRE PRESSURE WARNING RESET
SWITCH
When initializing the system, the present
tire inflation pressure is stored as stan-
dard. The tire pressure warning system
determines decreased air pressure by
comparing the present and the standard
tire inflation pressures. When you change
the set tire inflation pressure, it is neces-
sary to initialize the tire pressure warning
system.
! When rotating the tires on vehicles dif-
fering with front and rear tire inflation
pressures.
! When changing the tire inflation pres-
sure by changing traveling speed or
load weight, etc.
! When changing the tire size.
To initialize the system, perform the
following:
1. Park the vehicle in a safe place and
turn the ignition key to the “ACC” or
“LOCK” position.
2. Adjust the pressure of all the installed
tires (including spare) to the specified
cold tire inflation pressure level. (See
“Tires” on page 466 in Section 8.)
3. Turn the ignition key to the “ON” posi-
tion.
4. Push and hold the tire pressure warn-
ing reset switch until the tire pressure
warning light blinks slowly three times.
5. Wait for a few minutes with the ignition
key “ON”, and then turn the ignition
key to the “ACC” or “LOCK” position.
If you push the tire pressure warning re-
set switch while vehicle is moving, initiali-
zation is not performed.
If you push the tire pressure warning re-
set switch accidentally and initialization is
performed, adjust the tire inflation pres-
sure to the specified level and initialize
the system again.
07 05.22
To Next Page
Loading...
