Toyota 2008 Matrix - Positioning the Jack

’08 MATRIX_U (L/O 0706)
272
2008 COROLLA MATRIX from Aug. ’07 Prod. (OM12B26U)
CHECKING AND REPLACING FUSES
Parts (if replacement is necessary):
! Fuse with same amperage rating as
original
ADDING WASHER FLUID
Parts:
! Water
! Washer fluid containing antifreeze
(for winter use)
Tool s :
! Funnel
REPLACING LIGHT BULBS
Parts:
! Bulb with same number and wattage
rating as original (See charts in
“Replacing light bulbs” on page 294 in
Section 7−3.)
Tool s :
! Screwdriver
Front
Rear
When jacking up your vehicle with the
jack, position the jack correctly as
shown in the illustrations.
CAUTION
When jacking, be sure to observe the
following to reduce the possibility of
personal injury:
! Follow jacking instructions.
! Do not put any part of your body
under the vehicle supported by the
jack. Personal injury may occur.
! Do not start or run the engine while
your vehicle is supported by the
jack.
! Stop the vehicle on a level firm
ground, firmly set the parking brake
and put the transmission in “P”
(automatic) or reverse (manual).
Block the wheels on the opposite
side of the jack up point if neces-
sary.
! Make sure to set the jack properly
in the jack point. Raising the ve-
hicle with jack improperly posi-
tioned will damage the vehicle or
may allow the vehicle to fall off the
jack and cause personal injury.
Positioning the jack