’08 Rav4_U (L/O 0802)
267
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
Display: [995734]
Repeat the above procedure until the
entire number that you want to dial is
input.
Go back operation—
You say: [Go back]
Voice output: [Go back, the last num-
bers entered have been removed.
Push the talk switch and continue
adding numbers otherwise say dial,
go back, or delete.]
Display: [995]
Repeating the above operation deletes
the last digits in reverse order of in-
put.
Delete operation—
You say: [Delete]
Voice output: [Deleted. The entire
number to dial has been deleted.
Please push the talk switch and say
the number.]
Display: [Dial by Num]
The display will return to the initial
screen that allows a number to be
input.
Cancel operation—
Do either one of the following:
" Push the on−hook switch at anytime
during the operation.
" Push the talk switch and say [Can-
cel] after the beep at anytime dur-
ing the operation except while a call
is connected.
When receiving a phone call, a ring tone
is audible and the system changes into
the telephone mode.
When receiving a phone call, the display
is as follows. The display differs depend-
ing on whether or not the vehicle is in
motion.
When the vehicle is stopped:
Number, name, or [Incoming] is displayed.
When the vehicle is in motion:
[Incoming] is displayed.
Do either one of the following:
# Pushing the off−hook switch allows you
to talk on the phone.
# Pushing the on−hook switch refuses
the call.
To adjust the ring volume, push “+” or “−”
on the steering volume controls. Volume
adjustment cannot be done using the au-
dio system.
Repeatedly pushing “−” on the steering
volume controls mutes the ring.
When receiving an international phone
call, the name of the party may not be
displayed correctly depending on the cellu-
lar phone.
—Receiving a phone call
To Next Page
Loading...
