Toyota 2008 Rav4 - Page 31

’08 Rav4_U (L/O 0802)
21
2008 RAV4 from Feb. ’08 Prod. (OM42726U)
3. Open and remove the battery case
cover using a coin.
4. Take out the discharged battery and
put in a new battery with the positive
(+) side up.
5. Install the battery case cover and then
install the module into the key frame.
Close the cover.
6. When pushing either switch on the
wireless key, make sure the indicator
light comes on.
NOTICE
! Do not bend the terminals.
! Make sure the positive side and
negative side of the battery are
faced correctly.
! Do not replace the battery with wet
hands. Water may cause unexpected
rust.
! Do not touch or move any compo-
nents inside the transmitter, or it
may interfere with proper operation.
! Be careful not to bend the electrode
when inserting the battery and that
dust or oils do not adhere to the
battery case.
! Close the battery case securely.
After replacing the battery, check that the
key operates properly. If the key still does
not operate properly, contact your Toyota
dealer.