41
1-3. Opening, closing and locking the doors
1
Before driving
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at
least 5 seconds, and repeat step 2.)
n Battery-saving function
In the following circumstances, the entry function is disabled in order to pre-
vent the 12-volt battery from discharging and the electronic key battery from
depleting.
l When the entry function has not been used for 2 weeks or more
l When the electronic key has been left within approximately 7 ft. (2 m) of
the vehicle for 10 minutes or more
The system will resume operation when...
l The vehicle is locked using the door handle lock switch.
l The vehicle is locked/unlocked using the wireless remote control func-
tion. (→P. 47)
l The vehicle is locked/unlocked using the mechanical key. (→P. 382)
Multi-information
display
Unlocking doors Beep
Hold the driver's door han-
dle to unlock only the
driver's door.
Exterior: Beeps three
times
Interior: Pings once
Hold the front passenger's
door handle except the
driver’s door handle to
unlock all doors
Hold the front passenger's
door handle to unlock all
doors
Exterior: Beeps twice
Interior: Pings once
To Next Page
Loading...
