454
3-7. Other interior features
Press and hold the “SET/ ” button to confirm the direction
and to exit circling calibration mode. (If no buttons are
pressed for several minutes, the direction will automatically be
confirmed and the display returned to normal.)
Make sure that “•” on the left side of the direction display has
gone off. If “•” is illuminated, perform the above procedure
again.
■ Conditions unfavorable to correct operation
The compass may not show the correct direction in the following conditions:
● The vehicle is stopped immediately after turning.
● The vehicle is on an inclined surface.
● The vehicle is in a place where the earth's magnetic field is subject to
interference by artificial magnetic fields (underground car park/parking
lot, under a steel tower, between buildings, roof car park/parking lot, near
an intersection, near a large vehicle, etc.).
● The vehicle has become magnetized.
(There is a magnet or metal object near the accessory meter display.)
● The battery has been disconnected.
● A door is open.
■ Circling calibration error message (vehicles with Multi-terrain Select)
In the following situations, an error mes-
sage regarding the circling calibration will
appear on the accessory meter display
for a few seconds:
● The vehicle was driven too fast during
the circling calibration.
● The circling calibration was not com-
pleted successfully within about two
minutes.
To Next Page
Loading...
Need help?
General
