53
1-3. Opening, closing and locking the doors
1
Before driving
n Setting and canceling the functions
To s w i t c h bet w e e n set an d cance l e d , follow t h e proce d u r e b e l o w :
Close all the doors and switch the “POWER” switch to ON
mode. (Perform step 2 within 20 seconds.)
Shift the shift lever to P or N, and
press and hold the driver's door
lock switch (
or ) for
approximately 5 seconds and
then release.
The shift lever and switch posi-
tions corresponding to the
desired function to be set are
shown as follows.
Use the same procedure to can-
cel the function.
When the setting or canceling operation is complete, all doors are
locked and then unlocked.
Function
Shift lever
position
Driver’s door lock
switch position
Shift position linked door lock-
ing function
P
Shift position linked door
unlocking function
Speed linked door locking func-
tion
N
Driver's door linked door unlock-
ing function
To Next Page
Loading...
