Toyota 2012 Auris - Operation; Speech Command System

117
1. SPEECH COMMAND SYSTEM OPERATION
4
SPEECH COMMAND SYSTEM
AURIS_HB_WGN_HV_Navi_EE
14.03.12 15:00
1 Press the talk switch.
 The speech command system is acti-
vated.
2 After a beep sounds, say the desired
command or select the desired com-
mand.
: This icon will be displayed if the user
can speak a command.
MICROPHONE
It is unnecessary to speak directly into
the microphone when giving a com-
mand.
INFORMATION
 Wait for the confirmation beep before
speaking a command.
 Speech commands may not be recog-
nized if:
• Spoken too quickly.
• Spoken at a low or high volume.
• The windows are open.
• Passengers are talking while speech
commands are spoken.
• The air conditioning speed is set high.
• The air conditioning vents are turned
towards the microphone.
 In the following conditions, the system
may not recognize the command prop-
erly and using speech commands may
not be possible:
• The command is incorrect or unclear.
Note that certain words, accents or
speech patterns may be difficult for the
system to recognize.
• There is excessive background noise,
such as wind noise.
SPEECH COMMAND SYSTEM
OPERATION
 Press the talk switch to stop the cur-
rently played prompt and skip to the
next dialog step.
 In case of an activated speech recog-
nizer waiting for input, press the talk
switch to restart the speech recognizer.
(The recognizer drops the previous
input and waits for new input from the
user.)