TOYOTA CAMRY LE / SE / XLE 2012- DUAL SEAT HEATER KIT
Section II –Installation
Page 3 of 8
Form #5386, Rev. B, 07-11-2014
Install Heating Elements (cont’d)
9. Make sure vehicle floor-pan is clear and
carefully re-locate seat into vehicle.
10. Ensure all connectors under seat have been
properly connected and secured with wire ties,
and that nothing will be damaged upon seat
movement.
11. Install seat bolts and torque per service
manual.
12. Reconnect battery cable(s). Torque 10mm bolt
to 48 inch-pounds. Re-enter any theft
deterrent information, if applicable.
13. Note: If the passenger seat cushion has a Seat
Occupant Sensor for Airbag Deployment, it
must be re-calibrated per guidelines in the
Factory Repair Manual.
14. Place the Seat Heater Operation Instructions
in the glove box.
Figure 6
To Next Page
Loading...
