TOYOTA CAMRY LE / SE / XLE 2012- DUAL SEAT HEATER KIT
Section II –Installation
Page 5 of 8
Form #5386, Rev. B, 07-11-2014
9. NOTE: XLE models with SmartKey may be
pre-wired for the factory seat heater (Figure
12b). In this case remove the RED and
VIOLET wires from Pin 4 and Pin 13
respectively, and tape them to the harness as
shown in Figure 12c.
10. Secure the harnesses with wire ties to the
factory harness in center console and behind
the driver knee panel. Figures 11, 13 (Camry
LE / SE shown)
Figure 12a
Red
Wire
Pin 4
Blue
wire
Pin 13
Figure 13
Relays
Wire
Ties
Wire
Ties
Figure 12b
Figure 12c
Camry LE / SE
To Next Page
Loading...
