Rostra Precision Controls, Inc. - 2519 Dana Dr. - Laurinburg, NC 28352 - 800-782-3379 - rostra.com
Connect LCD-IN/TP-IN Extension Harness to the
navigation interface board.
Route the LCD-IN/TP-IN Extension Harness from
the radio’s interior through the opening in the back
of the housing.
Attach the included metal plate to the interior of the
vehicle’s dashboard using the supplied double-sided
tape.
Place the included GPS antenna atop the mounted
metal plate and allow its magnetic base to secure it
to the plate.
Located the threaded connector of GPS antenna.
Thread GPS antenna onto navigation module.
To Next Page
Loading...
