324
3-5. Other interior features
■ Programming the HomeLink
®
Point the remote control trans-
mitter for the device 1 to 3 in. (25
to 75 mm) from the HomeLink
®
control buttons.
Keep the HomeLink
®
indicator
light in view while programming.
Press and hold one of the
HomeLink
®
buttons and the
transmitter button. When the
HomeLink
®
indicator light
changes from a slow to a rapid
flash, you can release both but-
tons.
If the HomeLink
®
indicator light
comes on but does not flash, or
flashes rapidly for 2 seconds and
remains lit, the HomeLink
®
button
is already programmed. Use the
other buttons or follow the
“Reprogramming a HomeLink
®
button” instructions. (→P. 327)
STEP
1
STEP
2
To Next Page
Loading...
