Rostra Precision Controls, Inc. - 2519 Dana Dr. - Laurinburg, NC 28352 - 800-782-3379 - rostra.com
Release harnesses from rear of radio/screen.
Lift screen away from dashboard.
Navigation Interface Module Installation
ESD Warning: Do not handle the navigation interface circuitry without taking proper electrostatic discharge
precautions making sure both the installer and navigation unit are properly grounded before touching any interior
radio or navigation components. The warranty on this product is immediately voided if these precautions are not
taken and the navigation unit and/or radio are damaged due to electrostatic discharge.
Remove radio brackets from each side.
Remove screws securing the screen housing.
Use a trim tool to release the screen tabs and then
lift the housing to access the radio’s interior.
Remove the backing from the double-sided tape of
the nav board and secure it to the metal cover below
To Next Page
Loading...
