34
1-2. Opening, closing and locking the doors
■ Setting and canceling the functions
To switch between set and canceled, follow the procedure below:
Close all the doors and switch the engine switch to the “ON”
position. (Perform step 2 within 10 seconds.)
Shift the shift lever to P or N, and
press and hold the driver's door
lock switch (
or ) for
approximately 5 seconds and
then release.
The shift lever and switch posi-
tions corresponding to the
desired function to be set are
shown as follows.
Use the same procedure to can-
cel the function.
*: Vehicles with an automatic transmission only
When the setting or canceling operation is complete, all doors are
locked and then unlocked.
STEP
1
STEP
2
Function
Shift lever
position
Switch position
Shift position linked door lock-
ing function
*
P
Shift position linked door
unlocking function
*
Driver's door linked door unlock-
ing function
N
To Next Page
Loading...
Need help?
General
