EasyManua.ls Logo

Toyota 2015 4Runner - Page 229

Toyota 2015 4Runner
524 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
229
4-5. Using the driving support systems
4
Driving
4RUNNER (U)_(OM35B18U)
The following situations may occur during use.
Depending on the shape of the obstacle and other factors, the detection
distance may shorten, or detection may be impossible.
Obstacles may not be detected if they are too close to the sensor.
There will be a short delay between obstacle detection and display. Even
at slow speeds, there is a possibility that the obstacle will come within the
sensor’s detection areas before the display is shown and the warning
beep sounds.
Thin posts or objects lower than the sensor may not be detected for colli-
sion when approached, even if they have been detected once.
It might be difficult to hear beeps due to the volume of audio system or air
flow noise of air conditioning system.
If a message is displayed on the multi-information display
P. 421
Customization that can be configured at Toyota dealer
Settings (e.g. buzzer volume) can be changed.
(Customizable features P. 481)
Certification
For vehicles sold in the U.S.A.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions; (1) This device may not cause harmful interfer-
ence, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
For vehicles sold in Canada
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme a la norme NMB-001 du Canada.
Information Provided by:

Table of Contents

Other manuals for Toyota 2015 4Runner

Related product manuals