148
3-2. Opening, closing and locking the doors
HILUX_OM_OM0K196E_(EE)
■
Setting and canceling the functions
To switch between setting and canceling, follow the procedure
below.
Close all the doors and turn the engine switch to IGNITION ON
mode (vehicles with smart entry & start system) or the “ON” posi-
tion (vehicles without smart entry & start system). (Perform step
within 20 seconds.)
Shift the shift lever to other
than P (vehicles with auto-
matic transmission only), and
press and hold the driver’s
door lock switch ( or
) for approximately 5
seconds and then release.
The shift lever and switch posi-
tions corresponding to the
desired function to be set are
shown in the following table.
Use the same procedure to cancel the function.
When the setting or canceling operation is complete, all the doors are
locked and then unlocked.
1
2
2
Function
Driver’s door lock
switch position
Speed linked door locking function
Driver’s door linked door unlocking function
HILUX_OM_OM0K196E_(EE).book Page 148 Thursday, February 12, 2015 6:59 PM
To Next Page
Loading...
