285
4-5. Using the driving support systems
4
Driving
HILUX_OM_OM0K196E_(EE)
■ Replacing battery
→P. 526
■ Displaying the Stop & Start system status
Operation status of the Stop & Start system can be displayed on the
(Drive information) screen of multi-information display. (→P. 123)
The display of “After Reset” can be reset.
● To reset the display, press of the meter control switches, press “<” or “>”
to select “Reset”, and then press and hold .
● To stop the reset procedure, press .
■ Multi-information display messages
When the engine cannot be stopped by the Stop & Start system, and when
the engine automatically restarts while stopped by the Stop & Start system,
the following messages are displayed on the multi-information display.
● When the engine cannot be stopped by the Stop & Start system
Smart Stop
Displays the current engine stop time. Also, the
engine stop time when the air conditioning sys-
tem is on can be adjusted using the meter con-
trol switches. (→P. 284)
After Start
Displays the cumulative time that the engine is
stopped by the Stop & Start system from when
the engine is started until the engine is stopped.
After Reset
Displays the cumulative time that the engine is
stopped by the Stop & Start system from the
previous reset until the system is reset again.
Message Details/Actions
“Depress brake
firmly to activate”
The brake pedal is not depressed enough.
→ Operates when the brake pedal is
depressed further after stopping the
vehicle.
“For climate con-
trol”
Vehicles with automatic air conditioning sys-
tem:
• The air conditioning system is being used
when the ambient temperature is high or
low.
→ Readily operates when the difference
between the set temperature and cabin
temperature is small.
• is pressed.
HILUX_OM_OM0K196E_(EE).book Page 285 Thursday, February 12, 2015 6:59 PM
To Next Page
Loading...
