3
4
CALLING BY VOICE RECOGNITION
After the beep say, “Dial <number>.”
Say the phone number digits
individually, without pausing (e.g. “Dial
Three, one, zero, four…”).
step
2
step
3
Press on the steering wheel. After
the beep say, “Use the Phone.”
step
1
After the beep, say “Dial” or press
on the steering wheel.
Call is active when
is
indicated. To end call, press
on the screen or
on the steering
wheel.
step
4
Quick Tip - It is recommended that you reduce
background noise prior to using the Voice
Recognition system. Conversation, high fan speed,
wind noise (open windows), etc., may prevent the
voice recognition system from understanding your
commands.
Quick Tip - If you know your next command, you
can press
at any time to interrupt the prompt.
Speak your command after the beep.
Some Bluetooth
®
equipped cell
phones may or may not show battery or signal strength
on the display.
DIAL BY NUMBER
CONNECT A BLUETOOTH PHONE
Press
on the faceplate followed
by
. Verify that the
Bluetooth feature on the phone is ON
and is in discoverable mode.
step
2
step
3
step
1
If necessary, input the passkey listed on
the screen into the approved Bluetooth
cell phone. Please refer to the cell
phone manufacturer’s user guide for
pairing procedures.
Upon connection, the system will
indicate that the pairing process was
successful.
Quick Tip - Up to five Bluetooth cell phones can be
paired. However, only one Bluetooth cell phone can
be used at a time.
Pairing your phone is the first step in connecting with your Toyota for hands-free calling and for audio
streaming via Bluetooth. The pairing process is quick and easy: all iPhone mobile digital devices and
Android smartphones have Bluetooth integrated; all you have to do is setup the phone and multimedia
system to "talk" to each other and form a connection. Let's get started, first insure that your phone
Bluetooth setting is turned on, then follow the steps below.
Quick Tip - You can skip Step 1 and say Dial
commands immediately from the Shortcut Menu.
To Next Page
Loading...
