322
5-8. Connecting Bluetooth
®
(Multimedia system)
PRIUS c_U (OM52F96U)
To turn auto connection mode on, set “Bluetooth* Power” to on.
(P. 324)
When you register a phone, auto connection will be activated. Always
set it to this mode and leave the Bluetooth
®
phone in a place where a
connection can be established.
When the engine switch is turned to the “ACC” or “ON” position (vehicles
without a smart key system) or the “POWER” switch is turned to ACCES-
SORY or ON mode (vehicles with a smart key system), the system will
search for a nearby cellular phone you have registered.
Next, the system automatically connects with the most recent of the
phones connected to in the past. Then, the connection result is displayed.
*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.
When auto connection has failed or “Bluetooth* Power” is turned off,
you must connect the Bluetooth
®
device manually.
*: Bluetooth is a registered trademark of Bluetooth SIG, Inc.
Follow the steps in “Connecting a Bluetooth
®
device” from “STEP
1”. (P. 321)
Registering an additional device
Select “Select Device” on the Bluetooth
®
audio control screen.
For more information: P. 31 9
Selecting a registered device
Select “Select Device” on the Bluetooth
®
audio control screen.
For more information: P. 32 1
■ Reconnecting a Bluetooth
®
phone
If the system cannot connect due to poor signal strength with the engine
switch is turned to the “ACC” or “ON” position (vehicles without a smart key
system) or the “POWER” switch is turned to ACCESSORY or ON mode (vehi-
cles with a smart key system), the system will automatically attempt to recon-
nect.
If the phone is turned off, the system will not attempt to reconnect. In this
case, the connection must be made manually, or the phone must be rese-
lected.
Auto connection
Manual connection
Connecting a Bluetooth
®
audio player
1
1
2
1
2
To Next Page
Loading...
