EasyManua.ls Logo

Toyota 2016 RAV4 Hybrid - Page 119

Toyota 2016 RAV4 Hybrid
660 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RAV4-HV_OM_OM42A56U_(U)
119
3-2. Opening, closing and locking the doors
3
Operation of each component
Back door operation
A buzzer sounds and the emergency flashers flash to indicate that the doors
have been locked/unlocked. (Locked: once; Unlocked: twice)
Power back door only (if equipped): A buzzer sounds and the emergency
flashers flash twice to indicate that the back door is opening/closing.
Power back door only (if equipped): The back door can be opened even if it
is locked. The back door and side doors will be unlocked when the power
back door is opened. Lock all the doors again when you leave the vehicle.
All the doors will not lock automatically after the back door has been opened
and then closed.
Security feature
If a door is not opened within approximately 60 seconds after the vehicle is
unlocked, the security feature automatically locks the vehicle again.
Jam protection function (vehicles with power back door)
If anything obstructs the power back door while it is closing/opening, the back
door will automatically operate in the opposite direction or stop.
When reconnecting the 12-volt battery (vehicles with power back door)
To enable the power back door to operate properly, close the back door man-
ually.
Back door closer (vehicles with power back door)
In the event that the back door is left slightly open, the back door closer will
automatically close it to the fully closed position.
Fall-down protection function (vehicles with power back door)
While the power back door is opening automatically, applying excessive force
to it will stop the opening operation to prevent the power back door from sud-
denly shutting.
Back door closing assist (vehicles with power back door)
If the back door is lowered manually when the back door is stopped at an
open position, the back door will fully close automatically.
Canceling the adjusted open position of the back door (vehicles with
power back door)
Press and hold the power back door switch on the back door until the buzzer
sounds 4 times, pauses momentarily, and then sounds 2 times. The open
position is initialized to the fully opened position.
Customization (vehicles with power back door)
Settings (e.g. power back door opening angle) can be changed.
(Customizable features: P. 621)

Table of Contents

Related product manuals