RAV4-HV_OM_OM42A56U_(U)
233
4-5. Using the driving support systems
4
Driving
■ Changing the pre-collision warning timing
Press or of the meter control switches and select
on the multi-information display.
Press or of the meter control switches and select ,
and then press .
Select “Sensitivity” and then press .
Each time is pressed, the operation timing of the pre-collision sys-
tem will be changed.
The operation timing setting is retained when the power switch is turned
off.
Far
The warning will begin to
operate earlier than with the
default timing.
Middle
This is the default setting.
Near
The warning will begin to
operate later than with default
timing.
1
2
3
1
2
3
To Next Page
Loading...
