Toyota 2016 SEQUOIA - Page 371

371
3-5. Using the other interior features
3
Interior features
Press and hold down one of the
buttons on the HomeLink
®
and
the button on the transmitter.
When the indicator on the
HomeLink
®
changes from a slow
to a rapid flash, you can release
both buttons.
If the HomeLink
®
indicator comes
on but does not flash, or flashes
rapidly for 2 seconds and remains
lit, the HomeLink
®
button is
already programmed. Use the
other buttons or follow the
“Reprogramming a HomeLink
®
button” instructions. (P. 373)
Test the operation of the
HomeLink
®
by pressing the
newly programmed button.
If programming a garage door
opener, check to see if the garage
door opens and closes. If the
garage door does not operate,
see if your garage transmitter is
of the Rolling Code type. Press
and hold the programmed
HomeLink
®
button. The garage
door has the rolling code feature
if the indicator (on the
HomeLink
®
) flashes rapidly for 2
seconds and then remains lit. If
your transmitter is the Rolling
Code type, proceed to the head-
ing “Programming a rolling code
system”.
Repeat the steps above to program another device for each of
the remaining HomeLink
®
buttons.