YARIS_SEDAN_OM_OM99M18z_(U)
105
2-3. Door and Locks
2
Before Driving
Automatic transaxle vehicles
● Function number 3 is the factory setting for your vehicle.
● There are only a total of three auto lock/unlock settings available for manual
transaxle vehicles, and six for automatic transaxle vehicles. Be sure to
press the unlock side of the driver’s door-lock switch the correct number of
times according to the selected function number. If the switch is mistakenly
pressed four times on a manual transaxle vehicle or seven times on an
automatic transaxle, the procedure will be cancelled. If this occurs, start the
procedure from the beginning.
● The doors cannot be locked or unlocked while the setting function is being
performed.
● The procedure can be cancelled by pressing the lock side of the driver’s
door-lock switch.
Current Function Number
Press unlock side of lock switch once
Function Number 1
Function Number 2
Function Number 3
Press 2 times
Press 3 times
Cancel setting
Press lock side of lock switch
Cancel setting
Wait for 3 second
Function set (The number of
beeps heard is the same as the
selected function number)
Press 4 times
Function Number 4
Press 5 times
Function Number 5
Press 6 times
Function Number 6
Press 7 times
■ Do not pull the inner handle on a front door
Pulling the inner handle on a front door while the vehicle is moving is dan-
gerous. Passengers can fall out of the vehicle if the door opens accidentally,
which could result in death or serious injury.
To Next Page
Loading...
