Toyota 4Runner 2003 - Page 228

’03 4Runner_U (L/O 0211)
222
2003 4RUNNER from Oct. ’02 Prod. (OM35804U)
(a) Programming the HomeLink

The HomeLink

in your vehicle has 3
buttons and you can store one program
for each button.
To ensure correct programming into the
HomeLink

, install a new battery in the
hand–held transmitter prior to program-
ming.
The battery side of the hand–held trans-
mitter must be pointed away from the
HomeLink

during the programming pro-
cess.
For Canadian users, follow the procedure
in “Programming an entrance gate/Pro-
gramming all devices in the Canadian
market”.
1. Decide which of 3 HomeLink

buttons
you want to program.
2. Place your hand–held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
the surface of the HomeLink

.
Keep the indicator light on the HomeLink

in view while programming.
3. Simultaneously press and hold the
hand–held garage transmitter button
along with the selected HomeLink

but-
ton.
4. When the indicator light on the
HomeLink

changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink

by
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
“Rolling Code” type. Press and hold the
programmed HomeLink

button. The ga-
rage door has the rolling code feature if
the indicator light (on the HomeLink

)
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the “Rolling Code” type, proceed to the
heading “Programming a rolling code sys-
tem”.
6. Repeat steps 2 through 5 for each re-
maining HomeLink

button to program
another device.
Programming a rolling code system
If your device is “Rolling Code”
equipped, it is necessary to follow
steps 1 through 4 under the heading
“Programming the HomeLink

” before
proceeding with the steps listed below.
1. Locate the “training” button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
door opener. Refer to the owner’s
guide supplied by the garage door
opener manufacturer for the location of
this “training” button.
2. Press the “training” button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
3. Press and release the vehicle’s pro-
grammed HomeLink

button twice. The
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.