WWW.MANUALS.WS
WWW.MANUALS.WS
’03 4Runner_U (L/O 0305)
153
2003 4RUNNER from Apr. ’03 Prod. (OM35820U)
TO ACTIVATE THE DOWNHILL ASSIST
CONTROL SYSTEM
1. Full–time four–wheel drive models—
Turn the four–wheel drive control
switch knob to the “L4” position.
The system will not operate if the four–
wheel drive control switch knob is in the
“H4” position.
Multi–mode four–wheel drive mod-
els—Turn the multi–mode control
switch knob to the “L4” position.
The system will not operate if the multi–
mode control switch knob is in the “H4”
position.
2. In order to make full use of the en-
gine brake, putting the transmission
in “L” or “2” is recommended.
5–speed automatic transmission—The sys-
tem will operate even if the transmission
selector lever is in “D”, “4”, “3” or “N”.
However, when it is in “L” or “2” the en-
gine brake can also be utilized enabling
the system to operate more effectively.
4–speed automatic transmission—The sys-
tem will operate even if the transmission
selector lever is in “D”, “3” or “N”. Howev-
er, when it is in “L” or “2” the engine
brake can also be utilized enabling the
system to operate more effectively.
3. Push the “DAC” switch to turn the
system on. The downhill assist con-
trol system indicator light on the in-
strument panel will come on.
Full–time four–wheel drive models—If the
downhill assist control system indicator
light flashes, the selector lever may be in
“N” or the four–wheel drive control switch
knob may be in the “H4” position.
If the indicator light does not come on
when the switch is pushed, contact your
Toyota dealer.
Multi–mode four–wheel drive models—If
the downhill assist control system indica-
tor light flashes, the selector lever may be
in “N” or the multi–mode control switch
knob may be in the “H2” or “H4” position.
If the indicator light does not come on
when the switch is pushed, contact your
Toyota dealer.
To Next Page
Loading...
