’05 4Runner_U (L/O 0504)
160
2UZ- FE engine
Four- wheel drive control switch
knob at “H4”
40 km/h (25 mph)
Four- wheel drive control switch
knob at “L4”
15 km/h (9 mph)
When the cruise control is being used,
even if you downshift from “D” to “4”,
engine braking will not be enabled be-
cause the cruise control is not cancelled.
For ways to decrease the vehicle speed,
see “Cruise control” on page 193 in this
Section.
CAUTION
Be careful when downshifting on a
slippery surface. Abrupt shifting
could cause the vehicle to skid or
spin.
(d) Using “3”, “2” and “L” positions
The “3”, “2” and “L” positions are used for
strong engine braking as described pre-
viously.
With the selector lever in ”3”, “2” or “L”,
you can start the vehicle in motion as
with the lever in “D”.
With the selector lever in “3” or “2”, the
vehicle will start in first gear and automat-
ically shift to third gear or second gear.
With the selector lever in “L”, the trans-
mission is engaged in first gear.
NOTICE
Be careful not to over- rev the en-
gine. Watch the tachometer to keep
engine rpm from going into the red
zone. The approximate maximum al-
lowable speed for each position is
given below for your reference:
Two- wheel drive models
1GR- FE engine
“3” 146 km/h (90 mph). . . . . . .
“2” 100 km/h (62 mph). . . . . . .
“L” 58 km/h (36 mph). . . . . . . .
2UZ- FE engine
“3” 146 km/h (90 mph). . . . . . .
“2” 100 km/h (62 mph). . . . . . .
“L” 58 km/h (36 mph). . . . . . . .
To Next Page
Loading...
