279
3-6. Other interior features
3
Interior features
AVALON_U_(L/O_0802)
Press and hold down one of the
buttons on the HomeLink
®
and
the button on the transmitter.
Continue holding down both but-
tons until the HomeLink
®
indica-
tor light changes from a slow
blink to a rapid flash. This will
take approximately 30 seconds.
Test the HomeLink
®
operation
by pressing and holding the
newly programmed button for 2
seconds. If programming was
successful, the garage door will
open and close.
If the garage door does not oper-
ate, press and hold the pro-
grammed button for at least 3
seconds. If the indicator light
flashes rapidly then remains
solid, your garage door opener is
Rolling Code type.
Skip STEP 4 and proceed to the
section “Programming a Rolling
Code system”.
Repeat the steps above to program another device for each of
the remaining HomeLink
®
buttons.
STEP
2
STEP
3
STEP
4
To Next Page
Loading...
