5. Voice Recognition (VR)
Your hands-free system uses menu-driven voice recognition (VR) for setup and
operation.
Pressing the Multi-function button activates a voice recognition session with your
hands-free system.
Voice recognition (VR) has two main menus:
— main phone/setup menu — available except when in a call
— call menu — available when a call is active.
When you begin a VR session, you’ll hear a prompt and then a short beep. This short
beep - also known as a listening prompt - indicates that the hands-free system is
waiting for a verbal command from you.
Depending on which menu you are in, saying the predened commands allows you to
operate the hands-free system.
Some helpful tips during a voice recognition session:
— Voice recognition (VR) includes help prompts in every menu. While learning to use
the hands-free system, or whenever you need a reminder of the command list, say
Help. For some menus, you can also say Additional Help
— to repeat a prompt for a Yes or No question, say Repeat. The hands-free system will
repeat the question
— to immediately stop a prompt, press the Multi-function button. The hands-free
system returns to the listening prompt
— to return to the previous menu, say Cancel
— to exit the voice recognition session, say Exit or press the End button
— to increase/decrease the voice recognition session volume by a single level, press the
Volume Up or Volume Down button
— to increase/decrease the voice recognition session volume quickly, press and hold
the Volume Up or Volume Down button.
ó Note: Tones are played to indicate when the maximum and minimum volumes are
reached.
To Next Page
Loading...
