Initial pairing
ó Note: Before pairing, think of a suitable name for your handset device. For example
‘Jenny’s Phone’, ‘Karl’s RAZR’ etc.
ó Note: The process of initiating a Bluetooth® connection with a handset device varies
by manufacturer. Please have your device’s user manual available for reference, if
needed.
1 Your device’s Bluetooth® feature is o by default. To use your car hands-free system,
turn on the Bluetooth® feature in your device. See your device’s user manual.
2 Press and hold the Multi-function button.
The system responds: Set your device in scan mode and enter 0000 if prompted for
the passcode.
The Multi-function button ashes slowly during the pairing process.
3 Perform a device discovery from the device (see your device’s user manual). Your
device searches for any Bluetooth® devices around it. When searching is complete,
your handset device displays a list of the devices it nds. Searching may take a minute
or two to complete.
4 Select TOYOTA from the list of devices
5 On the device, enter the passkey 0000 (if prompted) and press the OK key.
The system responds: Pairing complete. Please say a friendly name for the device.
6 Say a friendly device name for your device. For example, you can say ”Jenny’s Phone”.
The system responds: <device name> added
7 On the device, if prompted to accept the Bluetooth® link, enter Yes.
After a few seconds, the system responds: Connection complete. The Multi-function
button is lit bright blue. Your hands-free system is now ready to make and receive
calls and/or stream music*.
Automatic connection
After initial pairing, every time you start your vehicle, your handset device and hands-
free system are automatically connected (if your handset device is powered on and the
relevant Bluetooth® settings are not changed).
If you start your vehicle, and your handset device is not present, the hands-free system
will automatically try to connect to other handset devices present in the device list.
When the wireless connection is established, the system responds: <device name>
connected.
ó Note: When in Expert Mode, the <device name> connected prompt is not played if last
connected device is reconnected. Instead you will hear two short beeps.
* On some models.
To Next Page
Loading...
