Call with digit segments
1 Press and hold the Mode button.
The system responds: Phone menu. {Say a command}.
2 Say Dial Number.
The system responds: Number please?
3 Say the rst segment of digits. (for example, say the rst three digits).
The hands-free system recites the digits heard.
4 Say the next segment of digits.
The hands-free system recites the digits heard.
5 Repeat step 4 until you have entered the complete phone number.
6 When the complete number has been entered, say Dial (or Yes) to dial the number.
ó Note: To delete a phone number segment, say Clear when prompted for the next
segment. The system responds: Last String Cleared, recites any remaining segments,
and waits for you to dictate a new segment.
ó Note: To delete all phone number segments dictated so far, say Clear All when
prompted for the next segment. The hands-free system clears all segments and
returns to the Number Please? prompt.
π Make a call using phone voice commands
For some handset devices, a voice tag must already be stored in the handset device to use
this feature. For other handset devices, this command may activate the handset device’s
internal VR application.
1 Press and hold the Mode button.
The system responds: Phone menu. {Say a command}.
2 Say Phone Voice Commands.
The system responds with the listening prompt.
3 Say <voice tag> (where <voice tag> is a voice tag stored in the handset device), or say
a command understood by the handset device’s VR application.
The hands-free device calls the number associated with the voice tag/VR command.
ó Note: Using this feature, you can dial numbers directly from your handset device’s
phonebook.
To Next Page
Loading...
