’06Camry_U (L/O 0507)
208
2006 CAMRY from July ‘05 Prod. (OM33708U)
HomeLink
Hand- held
garage
transmitter
25 to
75 mm
(1 to 3 in.)
2. Place your hand- held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
the surface of the HomeLink
.
Keep the indicator light on the HomeLink
in view while programming.
3. Simultaneously press and hold the
hand- held garage transmitter button
along with the selected HomeLink
but-
ton.
Do not release the buttons until step 4
has been completed.
4. When the indicator light on the
HomeLink
changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
by
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
“Rolling Code” type. Press and hold the
programmed HomeLink
button. The ga-
rage door has the rolling code feature if
the indicator light (on the HomeLink
)
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the “Rolling Code” type, proceed to the
heading “Programming a rolling code sys-
tem”.
To Next Page
Loading...
Need help?
General
