387
7
7-2. Steps to take in an emergency
When trouble arises
tions may be loose or corroded.
The engine starting system may be
malfunctioning due to an electrical
problem such as electronic key bat-
tery depletion or a blown fuse.
However, an interim measure is
available to start the engine.
(P.387)
One of the following may be the
cause of the problem:
The battery may be discharged.
(P.391)
One or both of the battery termi-
nals may be disconnected.
There may be a malfunction in
the (vehicles with smart entry &
start system).
Contact your Toyota dealer if the
problem cannot be repaired, or if
repair procedures are unknown.
When the engine does not start, the
following steps can be used as an
interim measure to start the engine
if the engine switch is functioning
normally:
1 Pull the parking brake switch to
check that the parking brake is
set. (P. 1 64)
Parking brake indicator will come on.
2 Shift the shift lever to P.
3 Turn the engine switch to ACC.
4 Press and hold the engine
switch for about 15 seconds
while depressing the brake
pedal firmly.
Even if the engine can be started
using the above steps, the system
may be malfunctioning. Have the
vehicle inspected by your Toyota
dealer.
The starter motor does not
turn over (vehicles with
smart entry & start system)
The starter motor does not
turn over, the interior lights
and headlights do not turn
on, or the horn does not
sound
Emergency start function
(vehicles with smart entry &
start system except manual
transmission)
To Next Page
General
