2005 SCION tC (EWD572U)
100
Power Window
1. Manual Up and Down Function
This function operates the window to open or close while the power window switch is being pulled up or pushed down
(Should be pulled up and down halfway for manual operation.). The window stops as soon as the switch is released.
2. One–Touch Auto Up and Down Function
”One–touch auto up and down function” enables the window of front doors to be fully opened or closed with a touch of the
power window switch.
3. Jam Protection Function
The jam protection function automatically stops the power window and moves it downward if a foreign object gets jammed in
the course of the window during one–touch auto–up operation.
4. Remote Control Function
The up and down operation of the front passenger door windows can be controlled by operating the power window master
switch.
5. Key–Off Operation Function
Within about 43 seconds when turn OFF the ignition SW or until the driver’s or passenger’s door is opened, this function
enables the door window operation with the power window master switch and/or the manual operation at each passenger’s
seat door.
∗ When the battery terminal or fuse is disconnected, the glass position of all door windows have to be reset to the initial
positions, one by one, with the power window control switch by following the procedure below:
A) Reconnect the battery terminal or fuse.
B) Turn ON the ignition switch.
C) Lower the window of each door halfway or more with the power window switch.
D) Then close the window fully with the power window switch.
Do not release the switch for at least 2 seconds after the window is fully closed.
P9 Power Window Master SW
10–Ground : Always approx. 12 volts
20–Ground : Approx. 12 volts with the ignition SW at ON position
2–Ground : Always continuity
: Parts Location
Code See Page Code See Page Code See Page
D9 36 J6 35 P11 37
D10 36 J9 35 P12 37
J4 A 35 P9 37
J5 B 35 P10 37
:
Relay Blocks
Code See Page Relay Blocks (Relay Block Location)
2 22 Engine Room R/B (Engine Compartment Left)
:
Junction Block and Wire Harness Connector
Code See Page Junction Block and Wire Harness (Connector Location)
1A 24 Floor Wire and Instrument Panel J/B (Lower Finish Panel)
1B 24 Engine Room Main Wire and Instrument Panel J/B (Lower Finish Panel)
1C
1D
1E
24
Instrument Panel Wire and Instrument Panel J/B (Lower Finish Panel)
1H
1M 25
System Outline
Service Hints
To Next Page
Loading...
