2005 SCION tC (EWD572U)
145
∗ The SRS airbag are provided for the driver and front passenger. The SRS airbags have been designed to help reducing
the shocks to the heads and chests of the driver and front passenger in the event of a severe frontal impact collision as
supplements to the seat belts.
This system is a 3–sensor type airbag system to detect the impact during a front collision using the airbag sensor
assembly center and airbag sensor (Front LH, RH), and to make the airbag system and pretensioner (LH, RH) operate as
well.
∗ In this system, a front side collision is detected by the side airbag sensor (LH, RH) in order to simultaneously deploy the
side and curtain shield airbags. A rear side collision is detected by the airbag sensor (Rear LH, RH) in order to deploy only
the curtain shield airbag.
∗ Dual–stage SRS airbags system, that controls the airbag inflating output optimum by judging the extent of impact and seat
position (Driver seat), has been used for the driver and front passenger airbags.
∗ In accordance with the adoption of the dual–stage SRS airbag system, a seat position sensor has been established for the
driver seat.
∗ This system has adopted a fuel cut control that stops the fuel pump when the airbag is deployed.
∗ The airbag stored inside the steering wheel pad is instantaneously expanded to soften the shock to the driver.
∗ The airbag stored inside the passenger’s instrument panel is instantaneously expanded to soften the shock to the front
passenger.
∗ Side airbags are instantaneously expanded to soften the shock of side to the driver and front passenger.
∗ The curtain shield airbag can ease an impact on the head of the front and rear passengers and reduce risks of injury.
∗ In a head–on crash, the driver moves forward and may strike his/her lower limbs against the instrument panel, etc. The
knee airbag is equipped to protect the lower limbs of the driver in head–on crashes.
∗ The pretensioners make sure of the seat belt restrainability.
: Parts Location
Code See Page Code See Page Code See Page
A4 32 C6 34 J9 35
A5 32 C11 36 K2 35
A11 A 34 C12 36 P13 37
A12 B 34 D4 34 P14 37
A13 C 34 E4 34 S9 37
A14 A 34 F6 36 S10 37
A15 B 34 F8 36 S11 37
A16 34 J4 A 35 S12 37
A18 36 J5 B 35
A19 36 J7 35
:
Junction Block and Wire Harness Connector
Code See Page Junction Block and Wire Harness (Connector Location)
1D
1E
24
Instrument Panel Wire and Instrument Panel J/B (Lower Finish Panel)
1M
Instrument Panel Wire and Instrument Panel J/B (Lower Finish Panel)
1S
25
:
Connector Joining Wire Harness and Wire Harness
Code See Page Joining Wire Harness and Wire Harness (Connector Location)
ID1 40 Front Door LH Wire and Floor Wire (Left Kick Panel)
IE3 40 Engine Room Main Wire and Instrument Panel Wire (Behind of the Combination Meter)
IG1 42 Instrument Panel Wire and Instrument Panel Wire Assembly (Behind of the Glove Box)
IH1 42 Engine Wire and Instrument Panel Wire (Cowl Side Panel RH)
IJ1 42 Floor No.2 Wire and Instrument Panel Wire (Right Kick Panel)
IK1 42 Front Door RH Wire and Floor No.2 Wire (Right Kick Panel)
System Outline
To Next Page
Loading...
