Toyota Sequoia - Page 239

239
4-5. Using the driving support systems
4
Driving
SEQUOIA_OM_USA_OM0C011U
■
Enabling/disabling the pre-collision system
The pre-collision system can be enabled/disabled on the
multi-information display as following:
The system is automatically enabled each time the engine switch is
turned to the “ON” position.
Press “<” or “>” of meter control switches and select .
Press “∧” or “∨” of meter control switches and select “PCS”, and
press .
Press “∧” or “∨” of meter control switches and select “PCS”, and
press to select the desired setting (on/off).
If the system is disabled, the
PCS warning light will turn on
and a message will be dis-
played on the multi-information
display.
Changing settings of the pre-collision system
1
2
3