03 SIENNA_U (L/O 0207)
20
2003 MY SIENNA (OM45410U)
Instrument panel
Center pillar
OPENING AND CLOSING WITH “DOOR
L”, “DOOR R” AND “PWR DOOR”
SWITCHES
To open the door, push the switch. To
close the door, push the switch once
again. The door opens and closes com-
pletely.
The “DOOR L” and “DOOR R” switches
are on the instrument panel. The “PWR
DOOR” switch is on the center pillar.
“DOOR L” switch—To operate the left side
door.
“DOOR R” switch—To operate the right
side door.
“PWR DOOR” switch—To operate both
side doors.
Opening and closing can be performed by
the switches under the following condi-
tions:
The sliding door is unlocked.
The power sliding door system is on.
(The “PWR DOOR OFF” switch is
pushed out.)
To open the power sliding door when
the ignition key is in the “ON” position,
the transmission selector lever must be
in “P”. (To close the sliding door from
the fully–opened or half–opened posi-
tion, the transmission selector lever is
not required to be in “P”.)
Left and right side power sliding door
models—The left side power sliding door
does not operate when the fuel filler door
is opened.
CAUTION
If you shift the automatic transmis-
sion selector lever out of “P” and
accelerate before the power sliding
door is closed completely, the sliding
door may reverse to the open posi-
tion. A child or others could fall out
of the vehicle and be injured. Always
make sure the power sliding door is
closed and latched before you start
driving.
To Next Page
Loading...
Need help?
General
