118
Chapter 15 VPN Server&Client
To use the VPN feature, you need to set up IPSec VPN Server on your mesh device, and
configure theIPSec connection on remote devices. Please follow the steps below to set
up the IPSec VPN connection.
Home Network Mesh Device (VPN Server) Remote Devices
Step 1. Set up IPSec VPN Server on Your Mesh Device
1. Visit http://tplinkwifi.net or http://192.168.88.1, and log in with your TP-Link ID or the
password you set for the mesh device.
2. Go to Advanced > VPN > IPSec VPN, and enable Dead Peer Detection.
Note:
• Firmware update may be required to support IPSec VPN Server.
• Before you enable Dead Peer Detection, we recommend you configure Dynamic DNS Service (recommended) or
assign a static IP address for mesh device’s WAN port and synchronize your System Time with internet.
3. Click Add.
4. Configure the IPSec VPN server parameters.
To Next Page
Loading...
