Chapter 5 Switching
Switching module is used to configure the basic functions of the switch, including five
submenus: Port, LAG, Traffic Monitor, MAC Address and DHCP Filtering.
5.1 Port
The Port function, allowing you to configure the basic features for the port, is implemented on
the Port Config, Port Mirror, Port Security , Port Isolation and Loopback Detection pages.
5.1.1 Port Config
On this page, you can configure the basic parameters for the ports. When the port is disabled, the
packets on the port will be discarded. Disabling the port which is vacant for a long time can
reduce the power consumption effectively. And you can enable the port when it is in need.
The parameters will affect the working mode of the port, please set the parameters appropriate
to your needs.
Choose the menu Switching→Port→Port Config to load the following page.
Figure 5-1 Port Config
The following entries are displayed on this screen：
Global Config
Specify the global jumbo size. The default maximum
transmission unit (MTU) size is 1518 bytes.
Port Config
Click 1 to configure the physical ports. Click LAGS
to
configure the link aggregation groups.
Select the desired port for configuration. It is multi-optional.
40
To Next Page
Loading...
