26
Stackable L2+/L3 Managed Switch
Figure 6-7 Port Settings
6. Type in the User name and Password in the Hyper Terminal window, the factory
default value for both of them is admin. The DOS prompt ”T3700G-28TQ>” will
appear after pressing the Enter button as Figure 6-8 shown. It indicates that you can
use the CLI now.
Figure 6-8 Log in the switch
■
Logon by Telnet
To log on to the switch by a Telnet connection, please take the following steps:
1. Firstly CLI commands about configuring Telnet login mode, login authentication
information and Privileged EXEC Mode password should be configured through
Console connection. For more details please refer to the CLI Reference Guide on the
resource CD. Here we take login local mode as an example.
2. Make sure the switch and the PC are in the same LAN.
Configuration
To Next Page
Loading...
