145
Admin Status: View and modify the Admin status. Choose 'Disable' to disable
the interface's Layer 3 capabilities.
Interface Name: View and modify the interface name.
Click Detail to display the following figure:
Figure 10-3 Detail Information
Detail Information
Interface ID:
Displays ID of the interface, including VLAN ID, loopback
interface and routed port.
IP Address Mode: Displays the IP address allocation mode.
None: without ip.
Static: setup manually.
DHCP: allocated through DHCP.
BOOTP: allocated through BOOTP.
IP Address: Displays the IP address and subnet mask of the interface.
Interface Status:
Displays the interface current working status, which is up when
Admin Status is enable, line protocol is up and IP address is set.
Line Protocol
Status:
Displays the line protocol status, which is up if any up-
connected to the interface.
Admin Status: Displays the Admin status. Choose 'Disable
interface's Layer 3 capabilities.
Interface Name: Displays the name of the interface.
To Next Page
Loading...
