TP-Link JetStream T2700G-28TQ - Page 184

172
Choose the menu Routing→RIP→Basic Config to load the following page.
Figure 10-27 RIP Basic Config
The following entries are displayed on this screen:

RIP Enable
RIP Protocol: Choose to enable or disable the RIP function. By
default is
disable.

Global Config
RIP Version: Choose the global RIP version.

Default: send with RIP version 1 and receive with both
RIP version 1 and 2.

RIPv1:send and receive RIP version 1 formatted packets
via broadcast.
 RIPv2:send and receive RIP v
ersion 2 packets using
multicast.