TP-Link JetStream T2700G-28TQ - Port Config

345
Choose the menu LLDP→Basic Config→Global Config to load the following page.
Figure 16-1 Global Configuration
The following entries are displayed on this screen:

Global Config
LLDP: Choose to enable/disable LLDP.

Parameters Config
Transmit Interval:
This parameter indicates the interval at which LLDP frames are
transmitted on behalf of this LLDP agent.
Hold Multiplier:
This parameter is a multiplier on the Transmit Interval that
determines the actual TTL
(Time To Live) value used in an
LLDPDU. TTL = Hold Multiplier * Transmit Interval.
Transmit Delay: This parameter indicates the delay between successi
ve LLDP
frame transmissions.
Reinit Delay:
This parameter indicates the amount of delay from LLDP becomes
"disable" until re-initialization will be attempted.
Notification Interval:
Configure the interval of Trap message which will be sent from
local device to network management system.
Fast Start Count: When the port's LLDP state transforms from Disable
(or Rx_Only)
to Tx&Rx
(or Tx_Only), the fast start mechanism will be enabled,
that is the transmit interval will be shorten to a second, and
multiple LL
DP frames will be sent out with the duration based on
this parameter.
16.1.2 Port Config
On this page you can configure all ports' LLDP parameters.