TP-Link JetStream T3700G-52TQ - Interface Range Ten-Gigabitethernet; Description

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
23.4 interface range ten-gigabitEthernet
Description
The interface range ten-gigabitEthernet command is used to enter the
interface range ten-gigabitEthernet Configuration Mode and configure
multiple Ten Gigabit Ethernet ports at the same time.
Syntax
interface range ten-gigabitEthernet port-list
Parameter
port-list —— The list of Ten Gigabit Ethernet ports.
Command Mode
Global Configuration Mode
User Guidelines
Command in the Interface Range ten-gigabitEthernet Mode is executed
independently on all ports in the range. It does not affect the execution on the
other ports at all if the command results in an error on one port.
Example
To enter the Interface Range ten-gigabitEthernet Configuration Mode, and
configure Ten Gigabit Ethernet ports 25 and 26 at the same time by adding
them to one port-list:
T3700G-52TQ(config)# interface range ten-gigabitEthernet 1/0/49-50
23.5 description
Description
The description command is used to add a description to the Ethernet port.
To clear the description of the corresponding port, please use no
description command.
Syntax
description string
no description
164