JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Syntax
ip igmp snooping vlan-config
vlan-list
[ immediate-leave
|
max-response-time
max-response-time
| rtime
rtime
| mtime
mtime
| rport
interface { fastEthernet
port
| gigabitEthernet
port
| ten-gigabitEthernet
port
| port-channel
port-channel-id
} | report-suppression
]
no ip igmp snooping vlan-config
vlan-list
[ immediate-leave
|
max-response-time | rtime | mtime | rport interface { fastEthernet
port
|
gigabitEthernet
port
| ten-gigabitEthernet
port
| port-channel
port-channel-id
} | report-suppression
]
Parameter
vlan-list
—— The ID list of the VLAN desired to modify configuration, ranging
from 1 to 4093, in the format of 1-3, 5.
immediate-leave —— Configure the Fast Leave function.
max-response-time
—— Specify the maximum responding time in seconds,
ranging from 1 to 25. The default aging time is 10 seconds.
rtime
—— Specify the aging time in seconds, ranging from 0 to 3600. The
default aging time is 0 second.
mtime
—— Specify the aging time in seconds, ranging from 2 to 3600. The
default aging time is 260 seconds.
port
—— Static Router Port, which is mainly used in the network with stable
topology.
port-channel-id
—— The ID of the port channel.
report-suppression
—— Enable the IGMP report suppression function.
When it is enabled, the switch forwards only the first IGMP report message
per mulicast group to the Layer 3 device, and the subsequent IGMP reports
from the same multicast group are discarded.
Command Mode
Global Configuration Mode
Example
Enable the IGMP Snooping function and modify Member Port Time as 200
seconds for VLAN1-3:
T3700G-52TQ(config)#ip igmp snooping vlan-config 1-3 mtime 200
256
To Next Page
Loading...
