TP-Link JetStream T3700G-52TQ - Page 34

T3700G-52TQ
JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide
Configuration Mode, Router Configuration Mode, DHCP Configuration Mode, MST
Configuration Mode and Class-Map Configuration Mode. Interface Configuration Mode can
also be divided into Interface gigabitEthernet, Interface link-aggregation and some other
modes, which is shown as the following diagram.
The following table gives detailed information about the Accessing path, Prompt of each mode
and how to exit the current mode and access the next mode.
Mode Accessing Path Prompt
Logout or Access the
next mode
User EXEC
Mode
Primary mode once it is
connected with the switch.
T3700G-52TQ>
Use the exit command to
disconnect the switch
(except that the switch is
connected through the
Console port).
Use the enable command
to access Privileged EXEC
mode.
Privileged
EXEC Mode
Use the enable command to
enter this mode from User
EXEC mode.
T3700G-52TQ#
Enter the disable or exit
command to return to
User EXEC mode.
Enter configure
command to access
Global Configuration
mode.
Global
Configuration
Mode
Use the configure command
to enter this mode from
Privileged EXEC mode.
T3700G-52TQ(config)#
Use the exit or the end
command or press Ctrl+Z
to return to Privileged
EXEC mode.
Use the interface
gigabitEthernet
port or
interface range
gigabitEthernet
port-list
command to access
interface Configuration
mode.
Use the vlan vlan-list to
access VLAN
Configuration mode.
Line
Configuration
Mode
Use the line vty command
from Global Configuration
mode to specify a line.
T3700G-52TQ(config- line)
Use the exit command to
exit to the global
configuration mode.
Press Ctrl-Z or enter end
to return to priviledged
EXEC mode.
11