TP-Link T1600-28TS - Show Mac Address-Table Interface; Show Mac Address-Table Count

121
Privilege Requirement
None.
Example
Display the security configuration of all ports:
T1600G-52TS(config)# show mac address-table max-mac-count
Display the security configuration of port 1/0/1:
T1600G-52TS(config)# show mac address-table max-mac-count interface
gigabitEthernet 1/0/1
16.12 show mac address-table interface
Description
The show mac address-table interface command is used to display the
address configuration of the specified port/LAG.
Syntax
show mac address-table interface { gigabitEthernet port | port-channel
lagid }
Parameter
port —— The Ethernet port number.
lagid —— The ID of the LAG.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the address configuration of port 1/0/1:
T1600G-52TS(config)# show mac address-table interface gigabitEthernet
1/0/1
16.13 show mac address-table count
Description
The show mac address-table count command is used to display the total
amount of MAC address table.