159
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Configure the Speed Mode as 100Mbps for port 1/0/3:
T1600G-52TS(config)# interface gigabitEthernet 1/0/3
T1600G-52TS(config-if)# speed 100
19.9 storm-control pps
Description
The storm-control pps command is used to configure the storm control
mode as pps(packets per second) on an interface. To disable the pps mode,
please use no storm-control pps command.
Syntax
storm-control pps
no storm-control pps
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
User Guidelines
This command should be used along with the storm-control command to
enable the storm control function and specify the detailed parameters in pps
mode.
Example
Set the storm control mode as pps on port 1/0/5:
T1600G-52TS(config)# interface gigabitEthernet 1/0/5
T1600G-52TS(config-if)# storm-control pps
To Next Page
Loading...
