TP-Link T1600-28TS - Spanning-Tree Hold-Count; Spanning-Tree Max-Hops

220
26.15 spanning-tree hold-count
Description
The spanning-tree hold-count command is used to configure the maximum
number of BPDU packets transmitted per Hello Time interval. To return to the
default configurations, please use no spanning-tree hold-count command.
Syntax
spanning-tree hold-count value
no spanning-tree hold-count
Parameter
value —— The maximum number of BPDU packets transmitted per Hello Time
interval, ranging from 1 to 20 in pps. By default, it is 5.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the hold-count of STP as 8pps:
T1600G-52TS(config)# spanning-tree hold-count 8
26.16 spanning-tree max-hops
Description
The spanning-tree max-hops command is used to configure the maximum
number of hops that occur in a specific region before the BPDU is discarded.
To return to the default configurations, please use no spanning-tree
max-hops command.
Syntax
spanning-tree max-hops value
no spanning-tree max-hops
Parameter
value —— The maximum number of hops that occur in a specific region
before the BPDU is discarded, ranging from 1 to 40 in hop. By default, it is 20.