TP-Link T1600-28TS - Show Ip Interface

319
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the information of VLAN 2:
T1600G-52TS(config)#show interface vlan 2
32.12 show ip interface
Description
This show ip interface command is used to display the detailed information
of the specified Layer 3 interface.
Syntax
show ip interface [ gigabitEthernet port | port-channel port-channel-id |
loopback id | vlan vlan-id ]
Parameter
port —— The port number.
port-channel-id —— The ID of the port channel. Member ports in this port
channel should all be routed ports.
id —— The loopback interface ID.
vlan-id —— The VLAN interface ID.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Privilege Requirement
None.
Example
Display the detailed information of the VLAN interface 2:
T1600G-52TS(config)# show ip interface vlan 2